The machine is formed by a tilting arm being by means of a pneumatic spring, said arm being fitted through an intermediary union to a radial arm being revolvable around 360º. The assembly is secured to the workbench by means of a base plate being provided with a post clearing the whole table area. The motor head finds itself at the end of the tilting arm and is apt to always move at right angles with respect to its working area.
The turning motor speed and the automatic lubrication control are adjustable by means of three buttons located on top of the motor cover. The modular system is apt to be fitted to the electronic motor and consists of 5 quick-change planetary speed reducers providing 5 different speeds and torques. The speed can be thus adapted to every thread type.

The toolholders (or tap holders) with or without safety clutch are also apt to be fitted to the modules by means of a quick-change system.

A range of 5 modules (speed reducers) can be coupled to the quick-change of the motor thus make available 5 different tool rotational speeds and obtaining by this way a great saving of time and energy.

The ROSCAMAT-6000 C-63 is supplied with an orientable head of easy handling which allows us to positionate the motor in 4 positions at 90º and tap in horizontal sites

The working height of the machine can be increased by 140 mm. in order to thus be in a position to work at different heights.

A wide range of tapholders, all of them with or without clutch, apart from other quick holding fixture for different tools, such as drills, sinking tools, threading dies, socket wrenches, etc. are available. Tapholder with safety clutch so that it slips when it reaches the hole bottom. Type 1 Ø19 mm: capacity range M2-M16 (for modules 900, 500, 320) Type 2 Ø31 mm: capacity range M14-M30 (for modules 140 & 75) Tapholder without safety clutch for holding different tools with cylindrical shank and driving cube. Type 1 Ø19 mm: capacity range M2-M16 (for modules 900, 500, 320) Type 2 Ø31 mm: capacity range M14-M30 (for modules 140 & 75)

Inside the radial arm the cutting oil reservoir is located. This is used for lubricating the tool during the tapping operation. The lubrication time according to the metric size to be done is adjusted by means of one of the upper head buttons.

Type: Servo motor BRUSHLESS TSV Power: 1400 W Maximum Torque: 185 Nm (75 rpm) Power: single-phase 220 V. Maximum speed: 900 rpm