Heavy load frames
Heavy load frames are specially conceived for STM cutting systems. They are inserted across the entire system width (bridge direction) between the screws cross beams in the cutting tank. The total height of the frames is chosen so that they fit beneath the standard grating position. Cutting can take place either with gratings or without. The 120 mm high insertable panels that are used offer a long service life due to their height and high strength for the heavy load frame because of their curved arrangement. The rectangular insertable panels are very easily fabricated and replaced.
Heavy load frames are primarily used if thicker materials (greater than approx. 40 mm) or heavy materials (greater than approx. 300 kg/m2) are to be cut. They can be used flexibly for almost every material type. With a rubber profile on the top edge of the insertable panels they are especially suited to use with sensitive materials such as glass or similar.
Product characteristics :
-
The insertable panels in the heavy load frame last longer than a grating because of their height.
-
Gratings can be used for longer on the heavy load frame.
-
Gratings can be used for longer on the heavy load frame.
-
Curved insertable panel arrangement reduces the reflection of waterjets during straight cutting and increases the overall strength.
-
Insertable panels are easily fabricated and replaced.
-
The number of insertable panels used can be varied.
-
Small and light parts can be cut as normal on the grating.
